Vega VEGAFLEX 83 Modbus and Levelmaster protocol PFA in Manual de usuario Pagina 58

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 96
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 57
58
9 Diagnostics and service
VEGAFLEX 83 • Modbus and Levelmaster protocol
41838-EN-130314
This status message is inactive by default. It can be activated by the
user via PACTware/DTM or EDD.
The following table shows the codes and text messages of the status
message "Failure" and provides information on causes as well as
corrective measures.
Code
Text mes-
sage
Cause Rectication PA DevS-
pec
Diagnosis
F013
no meas-
ured value
available
Sensor does not
detect an echo during
operation
Antenna system con-
taminated or defective
Check or correct
installation and/or
parameter adjustment
Clean or exchange
process component or
antenna
Bit 0
F017
Adjustment
span too
small
Adjustment not within
specication
Change adjustment
according to the limit
values (dierence
between min. and
max. ≥ 10 mm)
Bit 1
F025
Error in the
lineariza-
tion table
Index markers are not
continuously rising, for
examle unlogical value
pairs
Check linearization
table
Delete table/Create
new
Bit 2
F036
No op-
erable
software
Failed or interrupted
software update
Repeat software
update
Check electronics
version
Exchanging the elec-
tronics
Send instrument for
repair
Bit 3
F040
Error in the
electronics
Hardware defect Exchanging the elec-
tronics
Send instrument for
repair
Bit 4
F080
General software error Separate operating
voltage briey
Bit 5
F105
Determine
measured
value
The instrument is still
in the start phase, the
measured value could
not yet be determined
Wait for the end of the
switch-on phase
Duration depending
on the version and
parameter adjustment
up to approximately
3 min.
Bit 6
F113
Communi-
cation error
Error in the internal
instrument communi-
cation
Separate operating
voltage briey
Send instrument for
repair
Bit 7
Failure (failure)
Vista de pagina 57
1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 95 96

Comentarios a estos manuales

Sin comentarios