Vega VEGAFLEX 83 Modbus and Levelmaster protocol PFA in Manual de usuario Pagina 15
- Pagina / 96
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
15
3 Product description
VEGAFLEX 83 • Modbus and Levelmaster protocol
41838-EN-130314
VEGADIS 61 is an external display and adjustment unit for sensors
with single chamber housing and Ex-d double chamber housing.
It is suitable for measured value indication and adjustment of plics
®
sensors and is connected to the sensor with a four-wire standard
cable up to 50 m (164 ft) long.
You can nd further information in the operating instructions "VE-
GADIS 61" (Document-ID 27720).
VEGADIS 62 is suitable for measured value indication and adjustment
of sensors with HART protocol. It is looped into the 4 … 20 mA/HART
signal cable.
You can nd further information in the operating instructions "VE-
GADIS 62" (Document-ID 36469).
The PLICSMOBILE T61 is an external GSM/GPRS radio unit for
transmission of measured values and for remote parameter adjust-
ment of plics
®
sensors. The adjustment is carried out via PACTware/
DTM by using the integrated USB connection.
You can nd further information in the supplementary instructions
"PLICSMOBILE T61" (Document-ID 36849).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will nd additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
Screwed anges are available in dierent versions according to the
following standards: DIN 2501, EN 1092-1, ANSI B 16.5, JIS B 2210-
1984, GOST 12821-80.
You can nd additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The electronics module VEGAFLEX series 80 is a replacement part
for TDR sensors of VEGAFLEX series 80. There is a dierent version
available for each type of signal output.
You can nd further information in the operating instructions manual
"Electronics module VEGAFLEX series 80".
The electronics module Modbus is a replacement part for TDR sen-
sors of VEGAFLEX series 80.
You can nd further information in the operating instructions manual
"Electronics module Modbus VEGAFLEX series 80".
The display and adjustment module can be optionally replaced by a
display and adjustment module with heating function.
You can hence use the display and adjustment module in an ambient
temperature range of -40 … 70 °C.
You can nd further information in the operating instructions "Display
and adjustment module with heating" (Document-ID 31708).
External display and
adjustment unit
External display and ad-
justment unit with HAR
T
protocol
External radio unit
Protective cover
Flanges
Electronics module
Electronics module,
Modbus
Display and adjustment
module with heating
- Operating Instructions 1
- VEGAFLEX 83 1
- Quick start 2
- Contents 5
- 1 About this document 7
- 2 For your safety 8
- 2.6 NAMUR recommendations 9
- 3 Product description 10
- 3.2 Principle of operation 11
- 3 Product description 12
- 4 Mounting 17
- 5.1 Preparing the connection 21
- 5.2 Connection 22
- 4...20mA 23
- 6.1 Adjustment volume 25
- 6.3 Adjustment system 26
- 7.1 Connect the PC 47
- Fig. 23: Select quick setup 50
- 1 Quick setup 50
- 2 Extended adjustment 50
- 3 Maintenance 50
- 8 Set up with other systems 55
- 9 Diagnostics and service 56
- 9.3 Status messages 57
- 9 Diagnostics and service 58
- 9.4 Rectify faults 61
- 9.6 Software update 64
- 10 Dismounting 65
- 11 Supplement 66
- 41838-EN-130314 69
- 11.2 Basics Modbus 73
- Bus architecture 74
- Protocol description 74
- 11.3 Modbus register 75
- 11.4 Modbus RTU commands 77
- FC4 Read Input Register 78
- FC6 Write Single Register 78
- FC8 Diagnostics 78
- FC16 Write Multiple Register 79
- FC17 Report Slave ID 79
- 11.5 Levelmaster commands 80
- Report Unit Number 81
- Assign Unit Number 82
- Set number of Floats 82
- Set Baud Rate 82
- Set Receive to Transmit Delay 83
- Report Number of Floats 83
- Error codes 83
- Fisher ROC 809 84
- ABB Total Flow 85
- Thermo Electron Autopilot 86
- Bristol ControlWave Micro 87
- ScadaPack 88
- 11.9 Trademark 92
- Printing date: 96
Relacionado con productos y manuales para Equipo Vega VEGAFLEX 83 Modbus and Levelmaster protocol PFA in
(100 paginas)
(92 paginas)
(80 paginas)
(84 paginas)
Equipo Vega VEGATOR 636 Ex Manual de usuario
(28 paginas)
(28 paginas)
Equipo Vega VEGAFLEX 82 Profibus PA Manual de usuario
(100 paginas)
(100 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.235 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales